Home / Products / Power

Power

LEDs are low-voltage light sources, requiring a constant DC voltage or current to operate optimally. Operating on a low-voltage DC power supply enables LEDs to be easily adapted to different power supplies, permits longer stand-by power, and increases safety. During operation, the light source must be protected from line-voltage fluctuations. Changes in voltage can produce a disproportional change in current, which in turn can cause light output to vary, as LED light output is proportional to current and is rated for a current range. If current exceeds recommendations, the LEDs can become brighter, but their light output can degrade at a faster rate due to higher temperatures within the device which leads to a shorter useful life. LEDs, therefore, require a device that can convert incoming AC power to the proper DC voltage, and regulate the current flowing through the LED during operation. The driver converts 120V (or other voltage) 60Hz AC power to low-voltage DC power required by the LEDs, and protects the LEDs from line-voltage fluctuations.

  • View:
  • Grid
  • List

AU-MDEM43 Hour Maintained Panel Emergency Pack

3 Hour maintained emergency pack for use with LED modules, downlights and flat panels. .Includes converter, battery and LED charge indicator in a mesh sleeve. Maintained emergency pack for use with:.AU-LP103A/40.AU-LP105A/40

AU-ALD3510CC7 10W Non Dimmable Constant Current Driver

7-10W 350mA Non-Dimmable Constant Current LED Driver. For Constant Current LED lamps or luminaires it is necessary to wire the circuit in series in order for the current to remain constant. Overload, thermal & short-circuit protection. 1.0kV SURGE PROTECTION – EN 61547. Safety compliance - EN 61347, UL8750, UL1310, UL1012. EMC compliance - EN 55015, EN 61000, EN 61547. 3 year warranty.

AU-LEDD35107 10W Dimmable Constant Current Driver

Dimmable constant current LED driver for use with 350mA LEDs. Suitable for the supply of 7-10W 350mA LEDs.

AU-LED09IP3 9W IP68 Non Dimmable Constant Current Driver

These 350mA Constant Current LED Drivers are long lasting and also suitable for outdoor usage. They are IP68 so can survive jets of water or rain. Must not be permanently submerged however but can be used in moist areas or where rain can reach the area.

AU-LED09T1 9W Non Dimmable Constant Current Driver

350mA Non-Dimmable Constant Current LED Driver for use with 350mA 1W LEDs.

AU-ALD3516CC10 16W Non Dimmable Constant Current Driver

Registered Community Design 001886730.For Constant Current LED bulbs or fittings it is necessary to wire the circuit in series in order for the current to remain constant.Overload, thermal & short-circuit protection.1.0kV SURGE PROTECTION – EN 61547.Safety compliance - EN 61347, UL8750, UL1310, UL1012.EMC compliance - EN 55015, EN 61000, EN 61547.3 Year Warranty - see www.auroralighting.com for details

AU-LEDD351615 18W Dimmable Constant Current Driver

Suitable for the supply of 15-18W constant current LEDs. Dimmable with AU-DSP dimmers (de-rated to 50% loading).

AU-LEDD16CC1 18W Dimmable Constant Current Driver

1-10V Dimmable 350mA Constant Current LED Driver. Use AU-DSPLED 1-10V Dimmer to control (up to 40 - AU-LEDD16CC). 350mA Constant current output.

AU-LED709IP3 9W IP68 Non Dimmable Constant Voltage Driver

700mA Non-Dimmable Constant Current LED Driver.

AU-LEDD70101 10W Dimmable Constant Current Driver

Registered Community Design 001886730.Constant current LED driver for use with 700mA LEDs.AU-LEDD7010 Dimmable with AU-DSP dimmers (de-rated to 50% Loading).700mA constant current output.Suitable for the supply of 10W LEDs.Overload protection.Short-circuit protection.Thermal protection.Loop-in, loop-out primary wiring terminals.Integrated earth terminal for earth continuity.No junction box required.1.0kV SURGE PROTECTION – EN 61547.Safety compliance - EN 61347.EMC compliance - EN 55015, EN 61000, EN 61547.Series wiring only.3 Year Warranty - see www.auroralighting.com for details

AU-ALD7020CC20W Non Dimmable Constant Current Driver

Constant current LED driver for use with 700mA LEDs.Suitable for the supply of 20W LEDs.For Constant Current LED lamps or luminaires it is necessary to wire the circuit in series in order for the current to remain constant.Overload protection, thermal & short-circuit protection.Loop-in, loop-out primary wiring terminals.Integrated earth terminal for earth continuity.No junction box required.1.0kV SURGE PROTECTION – EN 61547.Safety compliance - EN 61347.EMC compliance - EN 55015, EN 61000, EN 61547.Non-dimmable.Series wiring only.3 Year Warranty - see www.auroralighting.com for details

AU-LEDD702012 24W Dimmable Current Driver

Dimmable constant current LED driver for use with 700mA LEDs. Dimmable with AU-DSP dimmers (de-rated to 50% loading). 700mA Constant current output. Suitable for the supply of 12-24W 700mA LEDs.

AU-LEDD703027 36W Dimmable Constant Current Driver

Constant current LED driver for use with 700mA LEDs. Suitable for the supply of 27-36W LEDs.

AU-LEDD101210W Dimmable Constant Voltage Driver

10W Dimmable 12V DC Constant Voltage LED Driver. Dimmable LED driver for use with Aurora Premium, Standard & Contractor 12V dimmable LED lamps. LED lamps must have more than one LED to allow dimming. Dimmable with AU-DSP dimmers (de-rated to 50% loading). Overload protection/Short-circuit protection/Thermal protection. 1.0kV SURGE PROTECTION – EN 61547. Safety compliance – EN 61347. EMC compliance – EN 55015, EN 61000, EN 61547. 3 year warranty.

Displaying results 1-15 (of 38)
 |<  < 1 - 2 - 3  >  >| 

Registered South Africa Address: Aurora Lighting (Pty) Ltd | Building 6, Ground Floor | Pinewood Office Park | 33 Riley Road, Woodmead | Gauteng, South Africa

TEL: +27 (0) 11 234 4878 | FAX: +27 (0) 11 234 3460

1999 - 2016 auroralighting.com

France

Select Location & Language

Aurora Lighting is a global organization serving markets around the world. Please select your region, or click below to visit our Global site to view our 2,500 products: